Neopro Tahoe-Veo Manual de usuario descargar pdf (Pagina 21)

DOC42-00035-A-Tahoe_Integrators_Guide.doc 21

Figure 2 - Save these two screws for attaching add-in card.

Installing the Cards

1) Put the ESD wrist strap on your wrist and attach the clip end to the

system chassis.

2) Remove 16 output card from it‘s ESD safe bag.

3) Install into the lowest numbered slot in the backplane board. Insert

edge connector in a straight down motion not angled. Push firmly to

ensure it is seated all the way.

4) Install 2 screws through the rear panel and into mounting brackets on

the 16 output card.

5) Replace the top cover, the 4 side screws, and the 5 rear flange screws.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 43 44

Sin comentarios

Neopro Tahoe-Veo Manual de usuario Pagina 21